QMS 2425 Especificações descarregar pdf (Página 48)

2SWLRQDO6HULDO

,QWHUIDFH

406785%2 3ULQ W6\VWHP2SWLRQV

1 Turn off the printer, and then disconnect the power cord and

all interface cables (parallel and Ethernet) from the printer.

2 Access the printer controller board.

Use the instructions in chapter 2, “Memory and System Software”

the “Removing the Controller Board” section, of this manual.

3 Remove the two screws from the optional interface plate.

Save the two screws. (You’ll use them when you install the

optional interface card.) You can either save or discard the plate.

4 Attach the serial interface.

a Position the serial connectors directly over the serial

connector pins on the controller board.

b Snap the serial connectors directly onto the serial connector pins.

c Press down on the connector gently until it is firmly seated on

the connector pins.

▲ Caution:

Do not push or pull from the ribbon cable. Use the

cable connector.

...................................

..................

.......................................

6HULDO

3RUW

5LEERQ

&DEOH

6HULDO

&RQQHFWRU

3LQV

6HULDOFRQQHFWRUV

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 227 228

Sem comentários

QMS 2425 Especificações Página 48