QMS SC-100 Guia de Configuração descarregar pdf (Página 45)

!9+#1!+2

$3

8!+$38#9(# )

b Tilt the SIMM up to a 90° angle until you feel it snap into place.

When seated, the SIMM stands

upright, firmly in place. If you

cannot snap the SIMM into place,

do not force it. Reposition it, mak-

ing sure that the bottom of the

SIMM is seated completely in the

connector.

8 Repeat steps 6–7 for each addi-

tional SIMM being installing.

9 Reinstall the controller board into

the printer.

Gently slide the controller board into

the printer until it is fully seated, and

then tighten the two screws.

10 Reconnect all interface cables.

11 Reconnect the power cord, and turn on the printer.

12 Print a start-up page.

Check that the start-up page states the total size of the RAM installed in your

printer.

13 If necessary, refer to the advanced status page you printed in step 1 to

reconfigure printer memory.

--/0

The time-of-day clock provides time and date information on the

startup page and in the accounting data.

!"#

The optional time-of-day clock kit includes only the following:

 Time-of-day clock

...................................................

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 45