QMS SC-100 Guia de Configuração descarregar pdf (Página 86)

100

5#30&+###

=#6>+



Disk swapping takes full advantage of the disk by allowing the printer to use the

hard disk to supplement RAM when necessary.

2 Turn the printer off and then on again to make this change take effect.

2!.:3;

(

»Note:

You cannot back up data to an internal or external hard disk.

Attach the Jaz or Zip drive to which you’ll be backing up data to the printer’s SCSI port

or SCSI chain. Then access the Administration/Disk Operations menu, and then press

the control panel keys in the order shown in the following table. The printer responds

by displaying a status message in the message window (DSK refers to the device,

and

is the device number).

»Note:

When backing up data to a Jaz drive, you should increase the Disk Cache

memory client to at least 750 KB. The recommended amount of memory for the disk

cache client for all disk drives should be 45 KB for internal use, plus 0.5 KB per MB of

disk storage, plus 120 KB of memory dedicated to caching.

»Note:

You may need to press the Next key one or more times to advance through the

list of selections or options.

Press this

key...

to... and the message

window reads...

Next Advance to the Disk Operations/ Backup Hard Disk

DISK

OPERATIONS

BACKUP HARD

DISK

Select Access the Backup Hard Disk/Dsk#: menu to find the

disk you want to back up (source).

BACKUP HARD

DISK

DSK

Next or

Advance through the list of attached devices to find

the disk you want to back up data to (destination).

BACKUP HARD

DISK

DSK

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Comentários a estes Manuais

Sem comentários

QMS SC-100 Guia de Configuração Página 86

Comentários a estes Manuais