QMS SC-100 Guia de Configuração descarregar pdf (Página 83)

/,#$#0

+

#0+ *

(see appendix A, “QMS Customer Support,” to find out how to access

Q-FAX documents).

»Note:

FAQ numbers may be subject to change, so you may want to obtain a directory

of Q-FAX documents before requesting a specific document.



For the printer to recognize one or more external storage devices, each device must

be turned on before you turn on the printer. If the printer recognizes the device(s) and

the start-up page is enabled, check to ensure that DISK ONLINE prints on that page.

If the start-up page is not enabled, print a status page and check to see if DISK

ONLINE prints on that page.

If DISK ONLINE does not print, see chapter 5, “Troubleshooting Printer Problems,” of

the

Operation

manual for more information.

Properly installed devices also appear in the “Options” section of the start-up page (if

it’s enabled) and on the status page as %%disk

%. (

is a 7 for an internal IDE hard

disk and 0-6 for any external SCSI hard disks or drives, depending on the SCSI ID set

on the back of the device.)

3)4

Keep the following in mind when using Jaz and Zip drives:

 Data can be backed up only to Jaz and Zip drives, not to external SCSI hard

disks.

 Jaz and Zip drive information shows up on the start-up and status page only if

media is present in the drive.

 If a Jaz or Zip drive is attached to the printer but no media is present, you will

experience a long delay (30 seconds or more) when you take the printer off line

and put it back on line.

 Jaz and Zip drives cannot be used for disk swapping or accounting. They can be

used only for font and file storage and for data backup and restoration.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 83