QMS SC-100 Guia de Configuração descarregar pdf (Página 58)

:(3#

7#$!#$39#



4 Attach the interface card to the controller board.

a Position the interface card so that its I/O connector slides into its opening in

the interface panel and that its 80-pin connector aligns with the 80-pin

connector on the controller board.

b Gently press the interface card down until its connector is fully seated and the

card is secured by the plastic support post(s).

▲ Caution:

Make sure that the connectors on the interface card and controller

board are properly aligned. Damage to the interface card and/or controller

board could result if the pins are misaligned.

5 Secure the interface card to the interface panel with the two screws you

removed earlier.

6 Reinstall the controller board.

Gently slide the controller board into the printer until it is fully seated, and then

tighten the two screws.

7 Reconnect all interface cables.

8 Reconnect the power cord, and turn on the printer.

9 Print a start-up page.

Check that the start-up page lists the interface just installed under “Options.”

...................................................

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 58