QMS SC-100 Guia de Configuração descarregar pdf (Página 50)

&#0

9(#



&—&—&..

%!$%—!!!

1 Send the new system image to the printer.

 Type

copy /b

filename

.ps lpt#↵

where

filename

refers to the name of the system software file (systemdl.ps is

a typical name) and # is the number of the parallel port (/b refers to binary

files.)

2 While the system software is loading, the Online LED blinks off and on, and

the message window displays

Downloading image

via parallel port.

3 After the new system software has been written to ROM, the printer returns

to IDLE.

»Note:

The new system image doesn’t erase the old image until the printer verifies

that the new image is valid.

4 Restart the printer to activate the new system software.

5 Print another advanced status page, and verify that the configuration set-

tings are the same.

%!$%—!

1 Connect the serial cable to the printer.

2 Set the PC’s baud rate to 38400 by typing

mode com # 38400 n 8 ↵

(where

is the serial communications port 1 to 4).

3 Access the Administration/Communication/Serial menu on your printer, set

the Hardware Flow Control RTS and CTS values to On, the baud rate to

38400, press the Online or Menu key, and then select yes to Save Changes.

4Type

copy /b

filename

.ps com

↵

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 50