QMS SC-100 Guia de Configuração descarregar pdf (Página 79)

90#0

+

#0+ 

!!(

Hard disks, Jaz drives, and Zip drives are identified by their device numbers. If the

printer has an internal hard disk, it has a device number of DSK7. If optional external

hard disks and/or drives are attached, their device numbers can be DSK0–DSK6.

Device numbers of external hard disks and drives can be set by the installer.

»Note:

If an internal hard disk is removed or an external hard disk or drive is not turned

on, the printer does not reset non-volatile RAM to the factory defaults.

▲ Caution:

If you connect to this printer an external hard disk you previously used with

an earlier QMS Crown printer (such as a QMS 2060, 2425, 4060, magicolor 2, or

magicolor 330), this QMS 3260/4032 Print System software release will automatically

reorganize the files on the hard disk when the printer is turned back on again. (The

printer release number is listed on both the start-up and the status page.) Once this

reorganization is done, the files on the hard disk can no longer be accessed if the hard

disk is reattached to an earlier QMS Crown printer.

This reorganization process takes time. If, when you first turn the printer on after

attaching a previously used hard disk, it does not come on line immediately, be

patient. Interrupting the reorganization process could cause all files on the hard disk to

be lost.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 79