QMS SC-100 Guia de Configuração descarregar pdf (Página 61)

9#

9##+#0" # *

 SCSI interface card ribbon cable

 Connector face plate

 Two larger screws

 Two smaller screws

&

▲

Caution: It's very important to protect the printer controller board and any associated

circuit boards from electrostatic damage. Before performing this procedure, review the

anti-static caution in “Anti-Static Protection” on page 4-2. In addition, always handle

circuit boards by the edges only.

1 Turn off the printer, and then disconnect the power cord and all interface

cables from the printer.

2 Loosen two screws (one on each end of the interface panel) and, using the

tab on the side of the panel, pull the controller board from the printer.

3 Remove the two screws holding the metal plate over the SCSI interface

opening.

The SCSI interface opening is labelled “SCSI.”

You can discard the metal plate and screws.

4 Attach the ribbon cable

to its connector on the

SCSI interface card.

5 Attach the SCSI inter-

face card to the con-

troller board.

a Position the SCSI

interface card so that

its ribbon cable

connector aligns with

the SCSI connector

on the controller

board.

...................................................

..................

...................

..................

...................

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 61