QMS SC-100 Guia de Configuração descarregar pdf (Página 47)

!9+#1!+2

$3

8!+$38#9(# *

a Locate the

time-of-day clock

socket on the

controller board

and the pin 1 notch

or printed label.

b Locate the pin 1

indicator mark on

the top of the

time-of-day clock.

This mark may be

a notch or a slight

depression on one

end of the clock.

c Align this indicator mark with the pin 1 notch or printed label on the controller

board.

d Gently press down on the time-of-day clock until it’s firmly seated.

 Caution:

Make sure that the pins on the time-of-day clock are properly

aligned with those in the receiving socket on the controller board. Damage to

the time-of-day clock and/or controller board could result if the pins are

misaligned.

4 Reinstall the controller board.

Gently slide the controller board into the printer until it is fully seated, and then

tighten the two screws.

5 Reconnect all interface cables.

6 Reconnect the power cord and turn on the printer.

7 Print a startup page.

Check that the time-of-day clock is listed under “options” on the startup page.

...................................................

Pin 1 Indicator Mark

Pin 1 Notch/Label

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 47