QMS SC-100 Guia de Configuração descarregar pdf (Página 80)

#$'#+3





Only one internal IDE hard disk is supported. However, you can add up to three exter-

nal SCSI hard disks, Jaz drives, and/or Zip drives to the printer.





’

/0

The IDE hard disk kit includes the following:

 IDE hard disk with ribbon cable attached

 IDE hard disk bracket

 3 screws

*!! 

▲ Caution:

It's very important to protect the printer controller board and any associated

circuit boards from electrostatic damage. Before performing this procedure, review the

anti-static caution in “Anti-Static Protection” on page 6-2. In addition, always handle

circuit boards by the edges only.

When installing or removing a hard disk, ensure that the metal support posts (on the

hard disk) don’t hit any of the electrical leads on the chips mounted on the controller

board. The controller board will not function if any of the leads are broken or shorted

together.

1 Turn off the printer, and then disconnect the power cord and all interface

cables from the printer.

2 Loosen two screws (one on each end of the interface panel) and, using the

tab on the side of the panel, pull the controller board from the printer.

3 Position the controller board on a flat surface so the controller board lies

flat and the interface panel is facing you.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 80