QMS SC-100 Guia de Configuração descarregar pdf (Página 82)

/,#$#0

+



7 Insert ribbon cable connector pin 1 (the colored stripe side of the cable) in

hard disk connector pin 1.

▲ Caution:

Make sure that the ribbon cable connector and the controller board

connector pins are properly aligned. Damage to the controller board could result if

the pins are misaligned.

8 Press down gently but firmly on the cable connector until it is fully seated.

▲ Caution:

Do not push or pull with the ribbon cable. Use the cable connector.

9 Align the support posts with the holes on the controller board, and then

press down to secure the hard disk to the controller board.

So that you don’t stress the board, press one corner at a time to secure the hard

disk to the controller board.

10 Reconnect all interface cables.

11 Reconnect the power cord and turn on the printer.

12 Print a start-up page.

Check that the start-up page indicates the presence of the hard disk.

%+!(

»Note:

You must have an optional SCSI interface board installed before you can attach

an external SCSI hard disk, Jaz drive, or Zip drive. Refer to the installation instructions

in chapter 3, “Interfaces and Daughterboards.”

0

For information on attaching an external SCSI hard disk, an Iomega Jaz drive, or an

Iomega Zip drive, see the documentation that comes with the device.

See FAQ 7181 for a list of each QMS-approved hard disk, its manufacturers and part

numbers, and the QMS products on which it can be used. You can access QMS FAQs

through the Internet at http://www.qms.com/support/supportbase/ or through Q-FAX

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 82