QMS SC-100 Guia de Configuração descarregar pdf (Página 70)

7)%

)-

2 Loosen two screws (one on

each end of the interface

panel) and, using the tab on

the lower side of the panel,

pull the controller board from

the printer.

3 Position the controller board

on a flat surface so the

controller board lies flat and

the interface panel is facing

you.

4 Remove the font SIMM from

the anti-static bag.

5 Insert the font SIMM into the

font SIMM connector.

Hold the SIMM at a 45° angle to the controller board, with the notch on the right

side and the bottom edge in the connector.

6 Tilt the SIMM up toward you to a 90° angle until you feel it snap into place.

When properly seated, the SIMM sits upright, firmly in place.

▲ Caution:

If you can’t snap the SIMM into place, don’t force it. Reposition it,

making sure that the bottom of the SIMM is seated completely in the connector.

7 Reinstall the controller board.

Gently slide the controller board into the printer until it’s fully seated, and then

tighten the two screws.

8 Reconnect all interface cables.

9 Reconnect the power cord and turn on the printer.

10 Print a start-up page.

Check that the start-up page indicates the font SIMM just installed under

“Options.”

It’s identified as

cartridge2%

11 Print an advanced status page.

...................................................

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 70