QMS SC-100 Guia de Configuração descarregar pdf (Página 57)

:(3#

7#$!#$39#

9##+#0" # 

 CrownNet Token-Ring (TCP/IP, NetWare, LAN Manager/LAN Server)

 DECnet-TCP/IP

 LocalTalk

You can install one of these interface cards in addition to the three standard inter-

faces—parallel, serial, and CrownNet 10BaseT/100BaseTX (TCP/IP, NetWare, Ether-

Talk, LAN Manager/LAN Server). The printer’s Simultaneous Interface Operation

(SIO) allows all of these interfaces to be active at the same time. In other words, your

printer can simultaneously communicate through all four ports with four hosts, either

computers or networks.

!$"#

An optional interface kit includes the following:

 An interface card

 Interface documentation (in hardcopy and/or on CD-ROM)

The kit may also include additional parts not required for network interface installation

on this printer.

&

▲

Caution: It's very important to protect the printer controller board and any associated

circuit boards from electrostatic damage. Before performing this procedure, review the

anti-static caution in “Anti-Static Protection” on page 4-2. In addition, always handle

circuit boards by the edges only.

1 Turn off the printer, and then disconnect the power cord and all interface

cables from the printer.

2 Loosen two screws (one on each end of the interface panel) and, using the

tab on the side of the panel, pull the controller board from the printer.

3 Remove the two screws holding the metal plate over the optional interface

opening.

The optional interface opening is labelled “Option.” It’s located next to the “Paral-

lel” port. Save the two screws. (You’ll use them when you install the optional inter-

face card.) You can discard the plate.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 99 100

Sem comentários

QMS SC-100 Guia de Configuração Página 57